The strange thing is that this occurs only on temperatures above 0 degrees Celsius. On temperatures below zero the engine runs smoothly.

Hi I've decided to give up lurking and start posting as I have a bit of an issue with my Focus 1.6 TDCI. 109. The car is a 08 plate, one of the few facelifts on the 08 plate. The engine has done around 170k and been with me for six years. The engine has had a replacement turbo prior to my ownersh
Posted January 8, 2017. Its in the owner manual as are the instructions for jump starting and charging. Basically always put the earth lead on the body charging post to the right of the battery and you will have no problems. NEVER disconnect the battery while the engine is running, That will do damage.
Ko gre za okvaro ECU v Ford Focus 1.6 TDCI, obstaja več simptomov, ki vam lahko pomagajo diagnosticirati težavo. Eden najpogostejših simptomov je nepravilno vžiganje motorja, ker računalnik vašega avtomobila pošilja napačne signale pogonski enoti. To se lahko zgodi, če eden ali več valjev v vašem motorju ne deluje pravilno.
I have recently taken my 2014 1.6 tdci to a tuner, they asked me to re-connect the battery after putting the ecu back in, after mapping. The car starts but runs very rough for a couple seconds and cuts out. Fault codes show - Faulty fuel injector driver within the PCM Could this be caused by conn Ford Focus TDCi - Ford Focus 2010 TDCi 1.6l Turbo Issues - hardway Have to agree with elekie doc on this one. If the mil lamp has come on then the cars computer (ECU) HAS detected a fault and switched the lamp on so there must be a fault code registered!

However his car would not rev at all in response to pressing the pedal down, the pedal pot had two tracks inside it which send a precise amount of voltage to tell the ECU how far the pedal is being depressed, the ECU then with the various readings determines the fuel and air ratio and adjust the fueling as required.

It is a little early (55 reg) for the 2006 cluster soldering problem, but still possible. It needs more detailed info about what lights come on and when, whether the immobiliser LED is flashing, and what code number it is flashing, and if Forscan can still communicate with the car at all.

Hi folks, I have a MK2.5 Focus, 1.6 TDCi from 2010. It's the pre-DPF model. It has developed recently an annoying fault, whereby when I am driving along regardless of speed or engine load. The centre screen pops up with 'Engine Malfunction!' when it does this the car makes the alarm noise like yo

Surely this should have been wiped from the ecu with the dpf removal and remap? Ford Model: Focus 1.6 TDCi Ghia & 2.0 the eloys tank with diesel to overcome
Ford Focus - Video tutorial. In this short video we will see how to proceed with a classic method that will allow us to reset the control unit on the Ford Focus first generation, following the instructions below. First of all, let's open the bonnet of our car and equip ourselves with a 10 mm socket or star wrench; after which we unscrew the two
.
  • q64qqozbca.pages.dev/490
  • q64qqozbca.pages.dev/341
  • q64qqozbca.pages.dev/413
  • q64qqozbca.pages.dev/114
  • q64qqozbca.pages.dev/64
  • q64qqozbca.pages.dev/494
  • q64qqozbca.pages.dev/10
  • q64qqozbca.pages.dev/18

    • ford focus 1.6 tdci ecu problems